CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
usb: core: port: Deattach Type-C connector on component unbind
connector_unbind() is the mirror of connector_bind(), but it is missing
the symmetric call to typec_deattach() that connector_bind() makes via:
if (port_dev->child)
typec_attach(port_dev->connector, &port_dev->child->dev);
When a Thunderbolt dock is unplugged, two teardown paths race:
1. The component framework calls connector_unbind() first, which sets
port_dev->connector = NULL without calling typec_deattach(). This
leaves port->usb2_dev/port->usb3_dev in struct typec_port pointing at
the USB device that is about to be freed.
2. usb_disconnect() then calls typec_deattach(port_dev->connector, ...),
but port_dev->connector is already NULL, so the call is a no-op and
port->usb2_dev is never cleared.
3. Concurrently, UCSI detects a PD partner-disconnect event and calls
typec_unregister_partner(), which reads port->usb2_dev (now a dangling
pointer to freed memory) and passes it to typec_partner_unlink_device()
-> sysfs_remove_link() -> dev_name() on the freed device, corrupting
the typec/UCSI partner state.
This corruption leaves the Thunderbolt tunnel in an inconsistent state on
the next dock hot-plug. On affected hardware the dock's I225/igc NIC fails
to enumerate: AER fires a slot reset while the igc driver is still
initialising ("PCIe link lost"), and the subsequent igc_reset attempt hits
igc_rd32 on an already-detached device:
igc 0000:2e:00.0 eth0: PCIe link lost, device now detached
igc: Failed to read reg 0x0!
WARNING: CPU: 9 PID: 129 at drivers/net/ethernet/intel/igc/igc_main.c:7005
igc_rd32+0xa4/0xc0 [igc]
Call Trace:
igc_disable_pcie_master+0x16/0xa0 [igc]
igc_reset_hw_base+0x14/0x170 [igc]
igc_reset+0x63/0x110 [igc]
igc_io_slot_reset+0x9e/0xd0 [igc]
report_slot_reset+0x5d/0xc0
pcie_do_recovery+0x209/0x400
aer_isr_one_error_type+0x235/0x430
aer_isr+0x4e/0x80
irq_thread+0xf4/0x1f0
4. UCSI later handles the PD partner-disconnect and calls
typec_unregister_partner(), which still sees the stale port->usb2_dev
and tries to remove its sysfs link a second time:
kernfs: can not remove 'typec', no directory
WARNING: CPU: 6 PID: 55 at fs/kernfs/dir.c:1706 kernfs_remove_by_name_ns+0xe9/0xf0
Workqueue: events ucsi_handle_connector_change [typec_ucsi]
Call Trace:
sysfs_remove_link+0x19/0x50
typec_unregister_partner+0x6e/0x120 [typec]
ucsi_unregister_partner+0x107/0x150 [typec_ucsi]
ucsi_handle_connector_change+0x3ec/0x490 [typec_ucsi]
process_one_work+0x18e/0x3e0
worker_thread+0x2e3/0x420
kthread+0x10a/0x230
ret_from_fork+0x121/0x140
ret_from_fork_asm+0x1a/0x30
With worse timing the same stale pointer is dereferenced after the
backing memory is freed, turning the warning into a use-after-free.
Fix the asymmetry: call typec_deattach() before clearing
port_dev->connector, matching what connector_bind() does on the bind side.
typec_partner_deattach() is already protected by port->partner_link_lock,
so it serialises safely with the concurrent typec_unregister_partner() path.