CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
binfmt_misc: use exe_file_deny_write_access() for the interpreter clone
For MISC_FMT_OPEN_FILE entries load_misc_binary() clones the
registered interpreter file and denies write access to the clone via
plain deny_write_access(). The clone is installed as
bprm->interpreter and later released by the exec machinery through
exe_file_allow_write_access() which skips the i_writecount increment
for files with FMODE_FSNOTIFY_HSM set.
The deny and allow side can therefore come to different conclusions
when pre-content watches are in play: if a pre-content watch is added
to the interpreter after registration every subsequent exec through
that entry takes a write denial on the clone that is never paired
with a write allowance, driving the interpreter inode's i_writecount
further down with each exec and leaving the interpreter unwritable
even after the entry and all its users are gone.
Take the write denial via exe_file_deny_write_access() so both sides
of the pairing base their decision on the same file mode, and
propagate failure instead of silently ignoring it: an interpreter
that is concurrently open for writing now fails the exec with
ETXTBSY, exactly like an interpreter freshly opened via open_exec()
would.