CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
mm/vmalloc: acquire init_mm lock on huge vmap to avoid ptdump UAF
Patch series "mm: fix UAF caused by race between ptdump and vmap pgtable
freeing", v6.
Kernel page table walkers fall into two broad categories - those ranges
where no exclusion is required via walk_kernel_page_table_range_lockless()
and those where exclusion is required via walk_kernel_page_table_range()
or walk_page_range_debug().
The former category is used only by arm64 arch code operating on ranges it
both wholly owns and does not concurrently write.
The latter category consists of kernel page table walkers operating on
ranges that are wholly owned (but which need exclusion against concurrent
writers).
The lock used for exclusion is the mmap lock, and for kernel ranges this
is the mmap lock on init_mm.
ptdump is a special case being both the only user of
walk_page_range_debug(), and the only case in which it walks ranges it
does not own.
This presents a problem, as page tables may be freed under ptdump. And
indeed there is a use-after-free bug in the kernel as a result, which this
series addresses.
vmap promotes page tables to huge leaf entries where possible, freeing the
lower page table when it does. It does this with no meaningful locks held
against concurrent ptdump walks.
As a result, use-after-free can currently occur. This series addresses
the issue by having the vmap huge promotion logic acquire the mmap read
lock while both setting the huge page table entry and freeing the prior
leaf page table.
The ptdump code already acquires the mmap write lock, so by doing so we
ensure that the ptdump walker only ever observes either the huge page
table entry or the existing page table entry, and nothing is freed
underneath it.
A mitigation for this issue was already applied for arm64 in commit
fa93b45fd397 ("arm64: Enable vmalloc-huge with ptdump"), which this series
has to deal with carefully.
This mitigation resolves the issue by acquiring the mmap read lock on
init_mm on vmap page table free if a ptdump is in progress.
However the fix in this series would cause a deadlock if we were to simply
apply it for arm64 without also reverting the change.
This is because vmap may acquire the read lock before ptdump attempts to
acquire the write lock, which then gets queued, and rwsem starvation rules
mean that the (unacknowledged) nested mmap read lock in the arm64 code
would also block, meaning the original read lock is never released and
thus deadlock.
This series works around this by #ifndef CONFIG_ARM64'ing the mmap read
lock in vmap logic, then partially reverting commit fa93b45fd397 ("arm64:
Enable vmalloc-huge with ptdump"), keeping the enablement of huge vmap
support, and removing the ifdeffery with the partial revert patch.
There are related issues that are also addressed in this series:
* x86 page attribute logic, specifically Change Page Attributes (CPA),
implements a feature whereby huge ranges can be collapsed into huge leaf
entries. This can similarly cause a UAF when done in parallel with a
ptdump walk, so similarly acquire the init_mm mmap lock to avoid this.
* The CPA logic allows concurrent page table manipulation and CPA
collapse, meaning the former risks accessing a page table the latter
frees. Fix this by acquiring mmap write lock on init_mm across the
whole CPA collapse operation and read lock on the page table
manipulation.
* x86 and arm64 permit walks of non-kernel mm's (both allowing efi mm
walks, and in x86's case arbitrary mm's), so we ensure kernel mappings
remain stable by locking the init_mm as well as the mm being walked.
The ordering of patches is established for both strict dependencies (the
arm64 partial revert in particular has to be done after the vmap changes)
and logical ones (the non-kernel mm fix only makes sense once the vmap/CPA
fixes are in place).
This patch (of 3):
Currently there is a nasty ra
---truncated---