CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
net: usb: ipheth: fix carrier_work UAF on disconnect
ipheth_sndbulk_callback() re-arms the carrier-check work on any
non-zero URB status:
else
schedule_delayed_work(&dev->carrier_work, 0);
Nothing ties that to the interface being up, so the work can be armed
again after ipheth_close() has already drained it, and stay armed
until the netdev whose private area embeds it is freed.
On unplug with a TX URB in flight, ipheth_disconnect() drains the work
through unregister_netdev() -> ipheth_close() ->
cancel_delayed_work_sync() and only then calls ipheth_kill_urbs().
usb_kill_urb() completes the in-flight TX URB with -ENOENT, so
ipheth_sndbulk_callback() runs after the drain and re-arms
carrier_work.
The same completion also re-arms the work if the interface is only
brought down while a TX URB is in flight, and
ipheth_carrier_check_work() then keeps re-queueing itself once a
second. unregister_netdev() does not call ipheth_close() for an
already-down interface, so nothing drains it on the later unplug
either.
In both cases free_netdev() frees the netdev while carrier_work is
still pending, and ipheth_carrier_check_work() dereferences freed
memory.
Tie the work to the interface state instead of chasing the completion:
disable it in ipheth_close() and enable it in ipheth_open(), so a
schedule_delayed_work() from the URB completion is a no-op whenever
the interface is not up. disable_delayed_work_sync() also waits for a
running instance, so it fully replaces the cancel_delayed_work_sync()
it takes the place of. The work starts out disabled in ipheth_probe()
so the enable/disable counts balance from the first open.
Reproduced under KASAN on linux-next (next-20260731) with dummy_hcd and
raw-gadget standing in for the device, driving the second path above (the
interface is already down, so unregister_netdev() does not call
ipheth_close()): 15 of 15 unpatched boots report a slab-use-after-free in
__run_timers(), freed by ipheth_disconnect() and re-armed from
ipheth_sndbulk_callback() via queue_delayed_work_on(). The
same trigger on a kernel differing only by this patch reports 0 of 15,
and the carrier check still functions across open/close cycles.
The reproducer needs an attached USB device that stops draining bulk OUT,
plus a link down and unplug, driven as root. It is not a privilege
boundary crossing and no exploit primitive was developed.
Found by 0sec (https://0sec.ai).