CVE-2026-74682
2026-08-22
16h16 +00:00
16h16 +00:00
Thông báo cho một CVE
Luôn được thông báo về mọi thay đổi đối với một CVE cụ thể.
Mô tả CVE
In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: fix OOB write on Type II inbound URBs
data_ep_set_params() sizes each URB transfer buffer before it adds the
Format Type II transfer delimiter:
u->packets = urb_packs;
u->buffer_size = maxsize * u->packets;
if (fmt->fmt_type == UAC_FORMAT_TYPE_II)
u->packets++; /* for transfer delimiter */
u->urb = usb_alloc_urb(u->packets, GFP_KERNEL);
buffer_size is computed from the pre-increment packet count and never
recomputed, so for a Type II endpoint the buffer is one packet short of
the packet count the URB is built with.
prepare_inbound_urb() then lays out one iso frame per packet and never
consults buffer_size:
offs = 0;
for (i = 0; i < urb_ctx->packets; i++) {
urb->iso_frame_desc[i].offset = offs;
urb->iso_frame_desc[i].length = ep->curpacksize;
offs += ep->curpacksize;
}
urb->transfer_buffer_length = offs;
urb->number_of_packets = urb_ctx->packets;
The last descriptor therefore points one packet past the end of the
transfer buffer, where the host controller writes device data on every
inbound transfer. prepare_silent_urb() and prepare_playback_urb() bound
their fill loops by ctx->buffer_size, so only capture is affected.
fmt_type comes from the device's audio streaming descriptors, so any
device advertising a Type II capture format hits this once userspace sets
hw_params on the stream.
KASAN on 7.2.0-rc5 (arm64) with a dummy_hcd/raw-gadget device, one report
per inbound transfer:
BUG: KASAN: slab-out-of-bounds in dummy_timer
Write of size 64 at addr ffff0000186171c0 by task cons02/166
__asan_memcpy
dummy_timer
hrtimer_run_softirq
Allocated by task 166:
usb_alloc_coherent
snd_usb_endpoint_set_params
The buggy address is located 0 bytes to the right of
allocated 64-byte region [ffff000018617180, ffff0000186171c0)
Compute buffer_size after the delimiter packet has been accounted for,
and bound the fill loop by buffer_size, as prepare_silent_urb() already
does on the outbound side. This grows every Type II URB allocation by
one maxsize packet.
Discovered by XBOW, triaged by Baul Lee
