CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
tls: device: fix out-of-bounds write in tls_append_frag()
Found with syzkaller and a local syzbot instance running on top of a
netdevsim TLS offload emulation; tls_device.c is otherwise only reachable
on a machine with a NIC that implements the offload.
tls_push_data() only checks whether the open record still has room for
another frag at the bottom of its loop, and the MSG_MORE early break
skips that check. The record survives to the next syscall with the frag
count it already had, and tls_append_frag() does not check either, so
with TLS_TX_ZEROCOPY_RO every splice(SPLICE_F_MORE) of a byte or two adds
a non-coalescing pipe page and num_frags walks off the end of
tls_record_info.frags[MAX_SKB_FRAGS]. Once the record is pushed,
tls_push_record() runs the same index over sg_tx_data[MAX_SKB_FRAGS] and
the sg_set_page() writes land on the destruct_work that follows it, which
the workqueue then calls.
The byte limit is fine because copy drops to 0 and the loop falls through
to the same check; the frag count has no such feedback.
Push the record rather than keep a full one open, which is what a plain
TCP socket does - tcp_sendmsg_locked() uses tcp_mark_push() and
new_segment in both the copy and the MSG_SPLICE_PAGES paths, and tls_sw
already sets full_record when the sk_msg ring fills up, MSG_MORE or not.
BUG: KASAN: slab-out-of-bounds in tls_append_frag ( net/tls/tls_device.c:269)
Write of size 8 at addr ffff8881104d1530 by task tls_oob/450
CPU: 2 UID: 0 PID: 450 Comm: tls_oob Not tainted 7.2.0-rc7+ #329 PREEMPT
Call Trace:
dump_stack_lvl (lib/dump_stack.c:94 lib/dump_stack.c:120)
print_report (mm/kasan/report.c:378 mm/kasan/report.c:482)
kasan_report (mm/kasan/report.c:595)
tls_append_frag (net/tls/tls_device.c:269)
tls_push_data (net/tls/tls_device.c:518)
tls_device_sendmsg (net/tls/tls_device.c:583)
inet_sendmsg (net/ipv4/af_inet.c:865)
sock_sendmsg (net/socket.c:775 net/socket.c:790 net/socket.c:813)
splice_to_socket (fs/splice.c:884)
do_splice (fs/splice.c:936 fs/splice.c:1349)
__do_splice (fs/splice.c:1431)
__x64_sys_splice (fs/splice.c:1634 fs/splice.c:1616)
do_syscall_64 (arch/x86/entry/syscall_64.c:63 arch/x86/entry/syscall_64.c:94)
entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:121)
and, once the record is pushed:
UBSAN: array-index-out-of-bounds in net/tls/tls_device.c:300:24
index 18 is out of range for type 'skb_frag_t [17]'
UBSAN: array-index-out-of-bounds in net/tls/tls_device.c:301:41
index 18 is out of range for type 'scatterlist [17]'
UBSAN: array-index-out-of-bounds in net/tls/tls_device.c:302:39
index 18 is out of range for type 'scatterlist [17]'
UBSAN: array-index-out-of-bounds in net/tls/tls_device.c:307:38
index 26 is out of range for type 'scatterlist [17]'
kernel tried to execute NX-protected page - exploit attempt? (uid: 0)
BUG: unable to handle page fault for address: ffffea000411a680
#PF: supervisor instruction fetch in kernel mode
#PF: error_code(0x0011) - permissions violation
Oops: Oops: 0011 [#1] SMP KASAN PTI
Workqueue: ktls_device_destruct 0xffffea000411a680
RIP: 0010:0xffffea000411a680
Call Trace:
worker_thread (kernel/workqueue.c:3405 kernel/workqueue.c:3486)
kthread (kernel/kthread.c:436)
ret_from_fork (arch/x86/kernel/process.c:158)
ret_from_fork_asm (arch/x86/entry/entry_64.S:245)