CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
serial: msm: Disable DMA for kernel console UART
At the moment, concurrent writes from userspace and the kernel to the
console can trigger a race condition that results in an infinite loop of
the same messages printed over and over again. This is most likely to
happen during system startup or shutdown when the init system starts/stops
a large number of system services that interact with various kernel code.
When userspace writes to the TTY device, the driver initiates an
asynchronous DMA transfer and releases the port lock. At the same moment,
the kernel printk path might grab the port lock and re-configure the UART
controller for PIO, without waiting for the DMA operation to complete. It
seems like this collision results in zero progress being reported for the
DMA engine, so the same text is printed to the console over and over again.
For the kernel console, we want a reliable output path that will be
functional even during crashes etc. So rather than implementing complex
code to synchronize the kernel console write routines with the userspace
DMA write routines, simply disable DMA for the console UART instance.
Similar checks exist in many other serial drivers, e.g. 8250_port.c,
imx.c, sh-sci.c etc.