CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
net/sched: act_ife: Only operate on Ethernet frames
act_ife encapsulates/decapsulates the original Ethernet header and uses
skb->dev->hard_header_len as the length of that header. That is only
correct for Ethernet devices: on a device where hard_header_len does not
match the L2 header that was actually pulled (PPP reports PPP_HDRLEN
while nothing is stripped on ingress), the ingress skb_push()/skb_pull()
use the wrong length and can hit skb_under_panic when headroom is tight.
IFE is Ethernet-only by design - it builds an outer ethhdr, rewrites
h_source/h_dest/h_proto, and calls eth_type_trans() on decode - so
instead of trying to make the offsets work for arbitrary link types,
simply drop packets that do not carry an Ethernet header.
Checking skb->dev->type alone is not enough. We have to cater for a
corner case where mirred can redirect an skb from a non-Ethernet device
to an Ethernet one, and skb->dev then says nothing about the framing the
skb actually has: an skb redirected from ppp0 reaches the target's ingress
hook with mac_len 0 and no Ethernet header at all. So at ingress also
require mac_len to be ETH_HLEN. On egress mac_len is not maintained, so
the device type is all we have; a bogus redirect there yields a malformed
frame rather than an out-of-bounds push, and it would be malformed with or
without IFE.
That corner case is not theoretical - redirecting from ppp0 into a veth
that has an ife encode action on its ingress hook panics without this
patch:
skbuff: skb_under_panic: len:98 put:14 head:ffff88800e410000
data:ffff88800e40fff5 tail:0x57 end:0x640 dev:veth3
kernel BUG at net/core/skbuff.c:214!
Call Trace:
skb_push (net/core/skbuff.c:224 net/core/skbuff.c:2657)
tcf_ife_act (net/sched/act_ife.c:829 net/sched/act_ife.c:874)
tc_run (net/core/dev.c:4463)
netif_receive_skb (net/core/dev.c:6463 net/core/dev.c:6522)
tcf_mirred_to_dev (net/sched/act_mirred.c:248 net/sched/act_mirred.c:328)
tcf_mirred_act (net/sched/act_mirred.c:489)
tc_run (net/core/dev.c:4463)
process_backlog (net/core/dev.c:6728)
With Ethernet framing guaranteed, use ETH_HLEN instead of
hard_header_len.