CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Quiesce notifications before teardown
scmi_notification_exit() clears and releases the notification instance,
but transport callbacks can still deliver incoming notifications until
the TX/RX channels are freed. During remove, an RX interrupt in that
window can enter scmi_notify() while notification state is being torn
down and then dereference freed memory. The same ordering exists on the
probe error path after notification initialization.
The notification late-init worker has a separate lifetime issue: protocol
event registration queues ni->init_work on the system workqueue, so
destroying ni->notify_wq does not drain that work. If the devres group is
released while init_work is still pending or running, the late-init worker
can dereference the freed notification instance.
Quiesce the notification core before TX/RX channels are torn down, then
clean up the channels before releasing the notification core resources.
Use disable_work_sync() so future late-init queueing is rejected and any
already queued or running late-init work has completed before channel
teardown starts.