CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
i3c: master: Fix recursive locking during device registration
i3c_master_register_new_i3c_devs() registers newly discovered devices
while holding i3c_bus_normaluse_lock(), a down_read(). device_register()
can immediately probe the device, and probe callbacks typically invoke
I3C helpers that take i3c_bus_normaluse_lock() again, leading to a
recursive acquisition of the same rwsem. rwsems do not support recursive
read locking and can deadlock when a writer is waiting. See the
"Recursive read locks" section of Documentation/locking/lockdep-design.rst.
For example, with Intel LPSS I3C, LOCKDEP generates a WARNING like:
# echo intel-lpss-i3c.0 > /sys/bus/platform/drivers/mipi-i3c-hci/unbind
# echo intel-lpss-i3c.0 > /sys/bus/platform/drivers/mipi-i3c-hci/bind
WARNING: possible recursive locking detected
kworker/5:1/94 is trying to acquire lock:
ffff88811c810d78 (&i3cbus->lock){++++}-{4:4}, at: i3c_device_match_id+0x45/0x370
but task is already holding lock:
ffff88811c810d78 (&i3cbus->lock){++++}-{4:4}, at: i3c_master_reg_work_fn+0x21/0x5f0
Fix this by separating device creation from device registration.
Populate desc->dev under the maintenance lock, collect the devices that
still need registration into a local list, then release the lock before
calling device_register(). Finally retake the lock and clean up any
devices that failed to register.
Use the maintenance lock rather than the normal-use lock while adding
device objects. A write-side maintenance lock prevents readers from
observing a partially initialized desc->dev during initial device
population, or desc->dev disappearing if registration fails.
The local list requires a list node, so add a list node member to struct
i3c_device.