CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
mm/mm_init: deferred_grow_zone(): fix out-of-range first_deferred_pfn
With CONFIG_DEFERRED_STRUCT_PAGE_INIT enabled, deferred_grow_zone()
initializes struct pages early in boot to satisfy an allocation.
With a large CMA reservation in place, the ranges deferred_init_memmap()
finds may not add up to the allocation it was asked for, and the function
ends up initializing the memory map of the entire zone and still falls
short.
That is fine in itself: the function accounts for it and leaves the
caller to decide whether it now has enough memory.
However, the update of pgdat->first_deferred_pfn that tracks where
uninitialized memory map starts could overflow.
If the node's RAM end is not aligned on PAGES_PER_SECTION boundaries and
some deferred struct pages were initialized, pgdat->first_deferred_pfn
would point past the end of the node's memory.
deferred_init_memmap() later picks up from pgdat->first_deferred_pfn and
hits a BUG_ON(), because it expects a pfn within its node.
For example, when running a kernel with CONFIG_DEFERRED_STRUCT_PAGE_INIT=y
and CONFIG_CMA=y using the following qemu command line
qemu-system-x86_64 -enable-kvm -m 8032M -kernel bzImage \
-append "nokaslr cma=4768M@0x100000000"
the kernel panics:
kernel BUG at mm/mm_init.c:2131!
CPU: 3 UID: 0 PID: 36 Comm: pgdatinit0 Not tainted 7.2.0-rc6 #1
RIP: 0010:deferred_init_memmap+0x1b8/0x1c0
RAX: 0000000000236000 R13: 0000000000238000
Call Trace:
kthread+0xdf/0x120
ret_from_fork+0x187/0x250
Make sure that the update of pgdta->first_deferred_pfn does not overflow
when the entire zone's (and therefore node's) memory map is initialized.
[rppt: massaged the changelog]