CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
mmc: spi: reset bytes_xfered before retrying CRC failures
mmc_spi_data_do() updates data->bytes_xfered after each block has been
transferred successfully. If a later block in the same data request
fails with a CRC error, data->bytes_xfered may therefore contain the
number of bytes completed before the failing block.
mmc_spi_request() has a private recovery path for such CRC failures. It
sends STOP_TRANSMISSION, clears data->error and jumps back to
crc_recover to issue the same command and data request again. However,
it does not clear data->bytes_xfered before the retry.
If the retry succeeds, the request is completed with the bytes from the
failed attempt still included in data->bytes_xfered. For a multi-block
request this can make the completed request report more bytes than were
transferred by the successful retry, and can even exceed the request size
when most blocks completed before the CRC error.
This is most likely to be observed on MMC-over-SPI systems where long
multi-block transfers occasionally hit a data CRC error but the
mmc_spi-internal retry succeeds. The data itself is retried, but the
completion accounting is not.
Clear data->bytes_xfered together with data->error before repeating the
request so the final completion reports only the bytes transferred by the
successful attempt.