CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
writeback: bound cleanup_offline_cgwb() rescans by rotating scanned inodes
cleanup_offline_cgwb() prepares at most WB_MAX_INODES_PER_ISW inodes
per call and is called again until the dying wb is drained, but every
call walks wb->b_attached and then wb->b_dirty_time from the same end.
Inodes already prepared (they stay on the list with I_WB_SWITCH set
until the switch worker runs) and inodes that cannot be switched
(I_FREEING, I_WILL_FREE, !SB_ACTIVE, DAX, already on the target wb)
stay where they are, so each pass rescans a growing run of them under
wb->list_lock and a full drain is quadratic in the number of inodes on
the list. With ~17M inodes attached to one dying cgwb we saw this end
in soft lockups, with CPUs reported stuck for 21-48s.
Walk both lists from the oldest end and move every scanned inode to
the newest end, so the next pass starts where the previous one stopped
and the drain becomes linear. b_attached is unordered, so nobody sees
the reorder there. b_dirty_time is ordered by dirtied_when, but the
oldest unscanned inode stays at the end move_expired_inodes() picks
from, sync takes the whole list regardless of order, and prepared
inodes leave the list as soon as the switch work runs and get a new
dirtied_time_when on the new wb anyway, so the only inodes left out of
order are the ones that can never switch (DAX), and only on the dying
wb.