CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
net: xps: reject an out of range traffic class
Only the entries below dev->num_tc are valid in dev->tc_to_txq[], and
dev->prio_tc_map[] may only name classes below it. netdev_set_num_tc()
lowers dev->num_tc without touching either array.
netdev_txq_to_tc() walks all TC_MAX_QUEUE slots and
netdev_get_prio_tc_map() returns the entry as it stands, so a leftover
entry is handed out as a traffic class >= dev->num_tc. Taking that
class from netdev_txq_to_tc(), __netif_set_xps_queue() rejects only a
negative one and indexes an XPS map sized for dev->num_tc classes:
tci = j * num_tc + tc;
RCU_INIT_POINTER(new_dev_maps->attr_map[tci], map);
attr_map[] holds nr_ids * num_tc entries and j runs over the ids named
in the mask, so a class that is not below num_tc pushes tci past the end
of the map for the last ids and the store overruns it.
Any caller that lowers num_tc leaves such entries behind, and
mqprio_destroy() tears down with netdev_set_num_tc(dev, 0) rather than
netdev_reset_tc(). After mqprio with 8 classes then 1, tc_to_txq[1..7]
still describe txq 1..7. The splat is from an XPS write to txq 2 on a
veth with 8 rx queues: attr_map[] has 8 * 1 entries, tci = j + 2, and
j == 6 stores one past the end of the 88-byte map:
BUG: KASAN: slab-out-of-bounds in __netif_set_xps_queue (net/core/dev.c:2954)
Write of size 8 at addr ffff88813016bc58 by task xps_oob/634
__netif_set_xps_queue (net/core/dev.c:2954)
xps_rxqs_store (net/core/net-sysfs.c:1880)
netdev_queue_attr_store (net/core/net-sysfs.c:1390)
Allocated by task 634:
__kmalloc_noprof (mm/slub.c:5439)
__netif_set_xps_queue (net/core/dev.c:2937)
The buggy address is located 0 bytes to the right of
allocated 88-byte region [ffff88813016bc00, ffff88813016bc58)
Reject a class the map has no room for.