CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
eth: fbnic: use the Rx queue napi pointer to find the napi vector
The queue management ndos pick the napi vector for an Rx queue with:
nv = fbn->napi[idx % fbn->num_napi];
The issue is this is only correct in the cases where there are no
standalone Tx vectors. In those cases we were allocating the Tx vectors
first and then the Rx so the queues would be pointing to Tx NAPI vectors
instead of the Rx ones.
The mapping the ndos want is already recorded. fbnic_set_netif_napi()
publishes it with netif_queue_set_napi(), which stores the napi pointer
in netdev_rx_queue.napi, and fbnic_reset_netif_napi() clears it again.
Both run under the netdev instance lock that the queue management ndos
also hold, so the pointer can be read directly.
Use it and drop the divide. The pointer is NULL exactly while the
datapath is down, so fbnic_queue_mem_alloc() can reject that case rather
than reaching into freed state: netdev_rx_queue_restart() calls it
before it tests netif_running(), and fbnic_pm_suspend() leaves
netif_running() true across a PCIe recovery that never completes, so a
queue restart can arrive after fbnic_stop() has freed the rings and the
vectors. fbnic_stop() clears the association in
fbnic_reset_netif_queues() before fbnic_free_napi_vectors(), so the
NULL is always published first. fbnic_queue_start() and
fbnic_queue_stop() need no check of their own, as
netdev_rx_queue_reconfig() only reaches them once fbnic_queue_mem_alloc()
has succeeded under the same instance lock.