CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
drm/i915/gt: Unmask interrupts only when ACTIVE is true
There is a small race window between intel_rps_boost() reading
a stale ACTIVE state and queuing rps->work, where ACTIVE may be
changed via asynchronous calls triggered by wakeref drop.
This means that rps_work() could be triggered after the GT has
been parked, so unmasking RPS PM interrupts would happen without
holding PM wakelock. This sequence of events may be observed
during live_rc6_ctx_wa() selftest:
1) live_rc6_ctx_wa()
-> intel_engine_pm_put()
-> wakeref_put()
ASYNC1) wakeref_put() callback
-> __engine_park()
-> intel_gt_pm_put_async()
-> intel_gt_pm_put_async_untracked()
-> intel_wakeref_put_async()
ASYNC2) wakeref_put_async() callback
-> __gt_park()
-> intel_rps_park()
-> intel_rps_clear_active() [clear ACTIVE]
WITH INTERRUPTS:
-> rps_disable_interrupts()
-> cancel_work_sync(rps->work)
-> rps_reset_interrupts() [rps->pm_iir = 0]
WITHOUT INTERRUPTS (TIMER mode):
-> rps_stop_timer()
-> cancel_work_sync(rps->work)
2) live_rc6_ctx_wa()
-> intel_gt_wait_for_idle()
-> intel_gt_retire_requests_timeout()
-> dma_fence_wait_timeout()
-> ops->wait() [i915_fence_wait()]
-> i915_request_wait_timeout()
-> intel_rps_boost()
-> intel_rps_is_active() [check ACTIVE]
[OPEN RACE WINDOW]
-> queue_work(rps->work)
-> retire_requests()
-> i915_request_retire()
-> intel_rps_dec_waiters() [from 1 to 0]
If ASYNC1 and ASYNC2 would execute during [OPEN RACE WINDOW],
then:
3) rps_work() executes from the workqueue and may satisfy
"(!pm_iir && !client_boost)" test (in TIMER mode rps->pm_iir
is zeroed by an earlier rps_work() call or never gets a new
value after previous intel_rps_unpark() event), so it jumps
to "out" label, bypassing intel_rps_is_active() guard and
executes gen6_gt_pm_unmask_irq();
4) GT is parked and runtime PM wakelock is dropped, so only
a raw reference in __gt_park() ->
intel_display_power_put_async() remains for 100ms, then the
MMIO write in gen6_gt_pm_unmask_irq() detects missing
wakelock via assert_rpm_wakelock_held() and emits
"RPM wakelock ref not held during HW access" tainting kernel.
Commit 3e7abf814193 ("drm/i915: Extract GT render power state management")
dropped the "if (rps->interrupts_enabled)" guard that
gen6_pm_rps_work() had around this unmask in i915_irq.c.
INTEL_RPS_ACTIVE brackets the same window, since it is set in
intel_rps_unpark() before rps_enable_interrupts() and
rps_start_timer() and cleared in intel_rps_park() before
rps_stop_timer() and rps_disable_interrupts().
Skip unmasking when RPS is no longer active (reaching unmask
operation is independent of INTERRUPT mode). This does not
prevent RPS operation from resuming on the next unpark.
In interrupt mode, intel_rps_unpark() calls
rps_enable_interrupts(), which enables and unmasks the PM
interrupts. In timer mode, it calls rps_start_timer(),
restarting periodic engine-busyness evaluation. The timer
generates software RPS events and queues rps_work() directly,
independently of PM interrupt delivery. Neither mode requires
the late worker to unmask interrupts while the GT is parked
(cherry picked from commit ca4a6deadad15b91ee083afe445fa6bdbfb68206)