CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
In the Linux kernel, the following vulnerability has been resolved:
wifi: brcmfmac: fix P2P device removal race in brcmf_detach()
When the driver is removed while the user space process that created
the P2P device (e.g. wpa_supplicant) is still exiting, the P2P device
interface is removed twice and the kernel crashes.
The two paths are:
- wpa_supplicant, on exit, sends NL80211_CMD_DEL_INTERFACE for the P2P
device. nl80211_del_interface() holds RTNL and the wiphy mutex and
calls brcmf_p2p_del_vif(), which disables discovery and waits up to
1.5 s for BRCMF_E_IF_DEL. Then it calls brcmf_remove_interface(),
which unregisters the wdev and frees the vif and the ifp.
- brcmf_detach() sets the bus down, so BRCMF_E_IF_DEL never arrives,
and calls brcmf_remove_interface(ifp, false) for the same ifp.
brcmf_p2p_ifp_removed() reads ifp->vif and then blocks on
rtnl_lock(). When brcmf_p2p_del_vif() releases RTNL, it calls
cfg80211_unregister_wdev() on the wdev that was already unregistered
and freed.
The second list_del_rcu() of wdev->list faults on LIST_POISON2:
brcmfmac: brcmf_p2p_del_vif delete P2P vif
brcmfmac: brcmf_p2p_deinit_discovery enter
brcmfmac: brcmf_p2p_del_vif P2P: GO_NEG_PHASE status cleared
brcmfmac: brcmf_detach Enter
brcmfmac: brcmf_bus_change_state 1 -> 0
brcmfmac: brcmf_remove_interface Enter, bsscfgidx=1, ifidx=0
brcmfmac: brcmf_del_if Enter, bsscfgidx=1, ifidx=0
brcmfmac: brcmf_p2p_ifp_removed P2P: device interface removed
[1.5 s later, brcmf_p2p_del_vif() timed out]
brcmfmac: brcmf_remove_interface Enter, bsscfgidx=1, ifidx=0
brcmfmac: brcmf_del_if Enter, bsscfgidx=1, ifidx=0
brcmfmac: brcmf_p2p_ifp_removed P2P: device interface removed
Unable to handle kernel paging request at virtual address dead000000000122
Internal error: Oops: 96000044 [#1] PREEMPT_RT SMP
pc : _cfg80211_unregister_wdev+0x6c/0x264 [cfg80211]
Call trace:
_cfg80211_unregister_wdev+0x6c/0x264 [cfg80211]
cfg80211_unregister_wdev+0x10/0x1c [cfg80211]
brcmf_p2p_ifp_removed+0x84/0xb0 [brcmfmac]
brcmf_remove_interface+0x1f4/0x254 [brcmfmac]
brcmf_detach+0x88/0x180 [brcmfmac]
brcmf_sdio_remove+0x90/0x7b0 [brcmfmac]
brcmf_sdiod_remove+0x20/0xa0 [brcmfmac]
brcmf_ops_sdio_remove+0xbc/0x12c [brcmfmac]
sdio_bus_remove+0x38/0x144
device_release_driver_internal+0x1e8/0x2c0
device_release_driver+0x14/0x20
brcmf_sdio_bus_remove+0x2c/0x40 [brcmfmac]
brcmf_fwvid_unregister_vendor+0xd8/0x170 [brcmfmac]
__exit_compat+0x18/0x418 [brcmfmac_cyw]
__arm64_sys_delete_module+0x1ac/0x244
The log was taken with debug=0x406 on an i.MX 8M Plus board with a
CYW55513 (Sona IF513) on SDIO. The driver is the Ezurio backport of
brcmfmac from v6.18.22 on a 5.4-rt kernel. The code involved is the same
in mainline.
To reproduce:
1. Start wpa_supplicant on wlan0 and let it associate. It creates the
P2P device (iw dev shows "type P2P-device").
2. Stop wpa_supplicant and remove the driver without waiting for
wpa_supplicant to exit:
kill $(pidof wpa_supplicant)
rmmod brcmfmac_cyw brcmfmac
The crash is reproducible on that board.
For the interface without a netdev (the P2P device), take RTNL and the
wiphy mutex in brcmf_detach() before reading iflist, and remove it with
locked=true. If brcmf_p2p_del_vif() runs first, brcmf_detach() finds the
slot empty. If brcmf_detach() runs first, nl80211 does not find the wdev
any more. The interfaces with a netdev are removed as before, because
brcmf_del_if() takes RTNL on its own for the primary interface.