CPE, viết tắt của Liệt kê nền tảng phổ biến, là một lược đồ đặt tên chuẩn hóa cho phần cứng, phần mềm và hệ điều hành. CPE cung cấp lược đồ đặt tên có cấu trúc để xác định và phân loại duy nhất các hệ thống công nghệ thông tin, nền tảng và gói phần mềm dựa trên các thuộc tính nhất định như nhà cung cấp, tên sản phẩm, phiên bản, cập nhật, phiên bản và ngôn ngữ.
CWE, hay Liệt kê điểm yếu phổ biến, là danh sách và phân loại toàn diện các điểm yếu và lỗ hổng phần mềm. Nó phục vụ như ngôn ngữ chung để mô tả các điểm yếu bảo mật phần mềm trong kiến trúc, thiết kế, mã hoặc triển khai có thể dẫn đến lỗ hổng.
CAPEC, viết tắt của Liệt kê và phân loại mẫu tấn công phổ biến, là tài nguyên toàn diện, có sẵn công khai ghi lại các mẫu tấn công phổ biến được đối thủ sử dụng trong các cuộc tấn công mạng. Cơ sở kiến thức này nhằm mục đích hiểu và diễn đạt các lỗ hổng phổ biến và các phương pháp kẻ tấn công sử dụng để khai thác chúng.
Dịch vụ và giá cả
Trợ giúp và thông tin
Tìm kiếm: ID CVE, ID CWE, ID CAPEC, nhà cung cấp hoặc từ khóa trong CVE
x86/kvm: Don't consume async #PF flags on a kernel #PF in NMI context
In the Linux kernel, the following vulnerability has been resolved:
x86/kvm: Don't consume async #PF flags on a kernel #PF in NMI context
An async #PF "page not present" event arrives through the #PF vector,
and its reason sits in the per-CPU apf_reason.flags until
__kvm_handle_async_pf() reads and clears it. If an NMI arrives after
the event is injected and before the #PF handler reads the flags, and
the NMI handler itself takes a #PF, that fault reads and clears the
flags belonging to the #PF it interrupted. It then finds interrupts
disabled in the NMI context it interrupted, and panics:
Kernel panic - not syncing: Host injected async #PF in interrupt
disabled region
Call Trace:
panic+0x52/0x60
__kvm_handle_async_pf+0xb0/0xb0
exc_page_fault+0x71/0xb0
asm_exc_page_fault+0x27/0x30
RIP: 0010:__get_user_nocheck_8+0x6/0x20
perf_callchain_user+0x147/0x1a0
get_perf_callchain+0x12d/0x1c0
...
perf_event_nmi_handler+0x26/0x50
exc_nmi+0xe8/0x110
RIP: 0010:asm_exc_page_fault+0x0/0x30
The last RIP line shows the NMI landing on the first instruction of
the #PF entry. perf with user call chains takes such a fault: the
sampling NMI walks the user stack with __get_user(), which faults when
a saved frame pointer is not a valid user address or the walk runs off
the top of the stack. The same window exists when KVM, running as an
L1 hypervisor with DELIVERY_AS_PF_VMEXIT, reads the flags itself after
a #PF VM-exit.
The NMI entry code saves and restores CR2 for this nesting, but not the
async #PF reason. Andy Lutomirski described the race, with perf as the
example, when async #PF delivery was reworked in 2020 [1]. Saving and
clearing the flags across the NMI, next to CR2, was discussed there but
not merged.
Since that rework, Linux has stopped setting KVM_ASYNC_PF_SEND_ALWAYS,
so the host delivers "page not present" only for user mode faults and
a kernel-mode fault in NMI context (including kernel-mode #MC and #DB)
cannot be an async page fault. In that case, return without touching
the flags so that the interrupted handler finds them intact.
Tested on v7.3-rc5 in a 4-vCPU, 2 GiB guest restored from a snapshot
whose memory is served on demand through userfaultfd, so that reading
it back takes async #PFs, while every thread samples hardware cycles
with user call chains and points its frame pointer at an unmapped page.
Without this patch the guest panicked as above in 3 of 3 runs. With it,
the guest survived 3 of 3 runs of 60 seconds, and the host counted
148,441 to 153,334 kvm_async_pf_not_present events in the first 20
seconds of each. On 6.18.50 the results were the same: the guest
panicked without the patch and survived with it.